ArtDio IPS-1000 Instrukcja Użytkownika Pobierz pdf (Strona 29)

1000 Series VoIP Gateway

5.4.3. PBX CO line access (trunk access code) configuration

When the ARTDIO IPH is connected to the extension line, you need to configure the PBX CO line access code with your

ARTDIO IPH, so that it is able to acquire the external phone line of the PBX automatically. If the access code is not configured,

Auto IP Searching and Outbound transit call functions won’t work.

You can configure the access code using the phone set. Pick up the handset and dial as follows:

1. ##0000 ; to start the configuring mode

2. 19 9

＊# ;assuming the prefix code is ‘9’. The “＊” key is used to set one second pause）。

3. Hang up the phone

Length of called phone number on Outbound Transit Calls

If the ARTDIO IPH has been configured with the PBX CO line access code, the ARTDIO IPH will presume that a PBX is

connected. For outbound transit calls, it can send to another extension line or pass through the PBX to a normal phone line. If

the Outbound Transit call is sent to another extension line, there is no need to include the PBX CO access code. However, if

the Outbound Transit calls are sent to a normal phone number, the

ARTDIO IPH will need to dial the PBX CO access code

before dialing the phone number. When the

ARTDIO IPH receives an Outbound Transit Call request from another ARTDIO IPH,

it will check the length of the called phone number (excluding the country and area code). If the length is 5 digits or more, the

ARTDIO IPH will dial the previously configured PBX CO access code along with the called phone number. Otherwise the

ARTDIO IPH will assume that it is an extension call. The PBX CO access code then has no effect.

Please refer to the following example.

The PBX CO access code is set to “9*” on

ARTDIO IPH A.

When

ARTDIO IPH B dials an Outbound Transit Call via ARTDIO IPH A using #0088635295004#, ARTDIO IPH A will

then dial the number “9”, then 5295004 after a one second pause (Because the called numbers has 7 digits [5295004]).

When

ARTDIO IPH B dials #008863110#, ARTDIO IPH A dials “110” without using the PBX CO access code; because the

called numbers is only 3 digits long (110).

5.4 Inspection

After connecting ARTDIO IPH to your network, we strongly suggest that you follow these procedures to check if ARTDIO

IPH is working properly.

Step 1：Check the LED of “TIME SRVR” on the front panel

If the “TIME SRVR” LED is on within 1 minutes of initial use, proceed to step 2. Otherwise perform the following

procedures.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 53 54

Brak uwag

ArtDio IPS-1000 Instrukcja Użytkownika Strona 29